Youtube daily report Sep 2 2017

Hello.

We continue to build wrought visor fabricated elements,

Now Let us give shape .Soberom

pattern, I folded over in a vise, more precisely by means of the clutches.

It turns out

convenient, accurate, there is no scuffing, marks. Can

buckle up to 18 bar, allows accurately at short

gaps, promote, and there will be no direct

areas.

Customize the second pattern, all with the same form as

It will be the same on both sides patterns.

It should be possible to make similar, both in form and

size.

To bend at short intervals using

rotator, and turns not much effort required,

and can be made smooth bends.

Thus it is possible to tighten thick bars in a loop

or nodes.

Thus Customized one below the other element,

and all along the pattern I make pairs.

I collected one pattern portion.

So it will look around the whole pattern.

Scald a little more than the joint, a couple of centimeters in one

see one side, and the second storonu.Sobral one sidewall

visor, said elements .Vot

scalded welding joints, This is partially a frequent

.Now gather

a second side the same pattern that was like a mirror

.Sdelal second display pattern

Gathered elements, the same added that the second

side. Next, I gather facial,

central pattern on which It will be a bunch. So

will look

the main trunk, with smooth the transition from 14

bar and ending with 10.

Fit to arc welded elements very grape

bunch.

Once added all elements that can scald

welded frame.

I take along a circle and stripping We clean the bar, neat welding

seams.

I am doing cutting wheel cuts grooves that the joints are not

allocated.

Cleaned out all the seams, made groove now joints, welding,

virtually invisible, only if you really look closely,

in brilliance, you can understand where the joint.

After painting with welding tyki impossible to see even

knowing where they are.

Yorshik on grinder I took all the slag, dross,

I prepared for painting .Prosverlil

mounting holes visor on vertical

frame and welded corners with fixing holes

of the visor in the the case will be set

on reinforced rods in monolith .so way

visor completely assembled, Now paint it. Visor

already painted, all quality painted, all the elements

three or four layers. Now you can

applied patina fasten polycarbonate. will continue

install visor .

This video was interesting, We subscribe to a channel.

Put huskies.

Bye everyone.