Engraving glass is a lot of fun and it's easier than you might think.
So let me show you what you need and how to do it.
I'm using a standard rotary tool with a flexible shaft extension.
The extension makes it a bit easier to do more detailed work, but you can also make do without.
Since glass is very hard, I'm going to be using a set of diamond coated bits.
There are a lot of different bits in this set, but a good place to start is with a
ball shaped one.
The engraving will cause a lot of fine glass dust, so make sure to wear a dust mask and
eye protection!
I'm using poster tacks to support the piece that I'm working on.
This will keep it stable without me having to hold it.
I'm going to practice a bit on an old wine bottle.
I set the Dremel at a medium speed and started engraving.
For now, I'm just freehanding a design.
I quickly figured out that you don't have to push down into the glass a lot, a light
touch is all it takes.
It's all about letting the tool do the work.
One direction of engraving will work better than the other.
This is because of the rotation direction of the tool.
For me, I did the best cutting when pulling the tool towards me, so I drew lines onto
the glass that way and lifted the tip up in between.
The engraving creates a reasonable amount of glass dust, which can make it difficult
to see what you're doing.
Keep a wet cloth and a bowl of water nearby, so you can wipe away the dust regularly.
This will make it look like your design is disappearing, but don't worry, once you dry the glass
it will reappear.
Now that I have a feel for the tool, I can move on to making a more detailed design.
I won't be freehanding this one, so I printed the design, cut it out and taped it to the
inside of the glass.
This way, all I have to do is trace the design onto the glass.
I switched to a smaller ball shaped bit to allow for the finer detail.
I changed the orientation of the glass several times along the way to make the engraving
a bit easier.
For the final details I switched to the thinnest bit that I had, which allowed me to write the tiny
letters on there.
Finally, I used the ball shaped bit again to add random stars all the way around the
glass to make the Tardis look like it's floating through space.
In some cases it won't be possible to tape your design to the inside of the glass,
like with this small carafe.
So I took some wide painter's tape and covered the printout with it, making sure the pieces
overlap.
I then cut out the inside of the design, leaving me with a silhouette.
I carefully peeled the tape off the paper and placed it onto the glass.
I'll still have to freehand the branches and the leaves, but being able to trace the outline
definitely helps a lot.
Alright, that's it for this one.
I really enjoyed engraving stuff, so I'm going to be trying this on a couple of different
materials, probably metal next.
But we'll see.
Let me know if you liked this video by leaving your likes and comments and questions and
everything down below and subscribe for my future videos.
If you want to see what's going on in between my videos then you can follow me on Instagram,
where I put previews and all sorts of things that I'm working on as well.
I'll see you next time.
Bye.
No comments:
Post a Comment