Hi, in the last days
many have asked
with which model I am recording my videos
or what´s inside of it etc.
and thus I´d like to give you an insight on my FPV wing
Here it is
it has already been built
When it´s fresh out of the box
then the fuselage is divided into two parts
Here you can see it
When it´s split, you can work on the inside part without any problems
and then after finishing, glue it up with UHU POR
By doing it like this
it´s much easier to assemble and fit all parts
A nice detail are the removable wings
I´ve got a small car
and I could never fit
anything with a wingspan of 130cm
in the trunk of my car
It is also quite easy to assemble
You put the big carbon rod right through here
and the smaller one at the back
That´s how it looks like
Should be quite familiar
for those that have built EPO wings before
In the wing there are the corresponding counterparts
You put it right in
and then it´s assembled
A nice detail is that
you don´t have to glue the wings on or use tape
Because on the backside of the wing
there´s a hex screw
and by tightening it
you´re clamping the carbon rod in place
Thus the wing cannot move
If you do it on both sides
the wings cannot break loose
On the inside
there´s a wooden box in the middle
you can see it in the background
it´s across the whole width
Nice thing is: at the bottom part
you can attach
some kind of a second level
There´s also 3D-printed parts for this
I just took some Coroplast and fitted it
It´s quite cool, because you´re then
gaining more space for batteries etc
and you can reach your Autopilot etc. quite easily
No comments:
Post a Comment