DIY Airgun Aerosol Suppressor MKII
Airgun Shooting and Related Activities
Do you remember what happened with the "Airgun Aerosol Suppressor" last time? (link in the description)
This time I used a PVC pipe as a "structural" reinforcement
and I glued the 1/2" UNF screw-nut into it.
This thin layer of Durepoxi was put there just to seal
the gaps between nut and pipe, so the other glue
used (Scotch Flex) did not flow out.
The nut outer diameter fits exactly the inner
diameter of the PVC pipe, so it is easier to
align it than glueing the nut directly into the can.
The cap must be removed completly, but keep
the o'ring seal and cover ring.
The output hole is about 10mm (0.39").
The pipe was glued top and bottom, the o'ring and
cover ring fitted perfectly.
Pellet trap at 10 meters (11 yards), as you can hear...
Same shots from another camera
Testing for influence on precision and accuracy (25 meters, 27.34 yards)
A little high, grouping is... ok...
Comparing it with a comercial suppressor
Enjoy it, share, subscribe and hit the notification bell!
Questions, suggestions, corrections are welcome. Thank you for watching.
For more infomation >> Geostorm Movie Trailer
For more infomation >> Live from Joes Inn - Best buddo to the stars - Duration: 14:33.
For more infomation >> Seat Altea 2.0 FSI STYLANCE AIRCO CLIMA TREKHAAK - Duration: 0:59.
For more infomation >> Jokes At Home - Capítulo 3 - (ACTIVAR SUBTITULOS) BROMA: AVIONCITO DE PAPEL :v - Duration: 2:45. 
No comments:
Post a Comment